GANA FILL PLLA Filler for Face

新商品

Gana Fill is made in Korea and approved by the KFDA. Gana Fill contains poly-L-lactic acid, which is a biocompatible, biodegradable substance that is gradually and naturally absorbed by the body and commonly found in dissolvable stitches. Gana Fill injectable that helps gradually replace lost collagen — an underlying cause of facial aging — for results that can last more than two years.

更多细节

17 商品

$199.99

基本信息

Gana Fill PLLA INJECTABLE POLY-L-LACTIC ACID POWDER FOR FACE

Reconstitute with 18ml of sterile water for injections 
One vial contains Injectable PLLA 520mg 
Made in Korea 

Gana Fill is a collagen stimulator which is used to diminish facial wrinkles by helping to restore the deep, underlying structure of the skin. Results appear gradually over the treatment regime (typically three injections over the course of three to four months) and can last more than two years.

As a poly-L-lactic acid (PLLA) collagen stimulator, Gana Fill is different from typical dermal fillers such as hyaluronic acid. Poly(L-lactide) is a biodegradable material with good bio-absorbability and bio-compatibility. After degradation in the body, PLLA products are excreted by metabolism and thus has no harmful side effects to the human body. It works with your body within the deep dermis, rather than topically, to help revitalize collagen production and help restore your skin’s inner structure and volume.1-3 As the PLLA microparticles are absorbed, they help stimulate collagen production. Rebuilt collagen strands begin gradually helping to restore facial volume4 and the look of fullness to wrinkles and folds.

Gana Fill PLLA

INJECTABLE POLY-L-LACTIC ACID POWDER 

Reconstitute with 18ml of sterile water for injections 
One vial contains Injectable PLLA 520mg 
Made in Korea 

Gana Fill VS other brands

1.Quicker dissolution time-under one hour
-If you have no time ,You can reconstitute water and shake well for 10minutes,
-if you use vortex mixer ,dissolution time will be under 60 seconds, shake 60seconds then just use it
2.Cheaper price
3.Larger quantity.GANAFILL 520mg VS other PLLA fillers 150mg (GANAFILL X 1560mg)
4.Better contouring effect
-because GANAFILL has more PLLA 
5.Less volume loss at first injection 
-In a few days of sculptra injection. There will be no augmentation, You will see Initial volume loss, You have to wait 1-2months until 
you see augmentation But GANAFILL has lower Volume loss 
6.Low nodule formation- more water more dilution lower grnuloma

GANA FILL PROCEDURE


1.Reconstitute with 18ml of sterile water at least 1hours before injection.
2.If you use vortex mixer ,dissolution time will be under 60 seconds.
3.Use blunt needle larger than 21G.
4.For subcutaneous injection. For better performance inject deeper.
5.Use fan technique and avoid injecting too much in one area.
6.Do not use for forehead, lips, nose or areas near the eyes.
7.Use for face, breast and hip volume augmentation and acne scar recovery.
8.Effects can be seen 4 weeks after treatment up until 8 weeks after treatment. Volume augmentation lasts for 2 years.
9.Vigorous massaging is necessary around the area of treatment for 30 minutes every day for the first week
10.Two or three session is needed

GANA FILL PLLA injection technique

Precaution
1.Do not treatment prohibited area.(lip, nose, forehead)
2.Use distilled water only. (Do not use a saline solution or water.)
3.Don't inject at one spot too much , inject widely and deeply to avoid granuloma formation
4.Patient have to get second treatment.(Check progress)